How To Put Bearings In Skateboard Wheels

Bearings play a major role in the efficiency of your skateboard especially how smoothly and fast your board can move. Fitting the properly will ensuring that the purpose of your skateboarding is met.

 In addition to making the decision of the best bearings for your skateboard and maintenance needed for the bearings, the installation of the bearings also determines the efficiency of the board. “How To Put Bearings In Skateboard Wheels?”, this is not an easily answerable question

It is not obvious that the most expensive bearings are the best; a set of ABEC-5S or 3S from a reputable dealer can also serve you wholesomely. Please make sure they are lubricated and cleaned well

. In most cases, you will find the best quality of bearings packaged that will last for some weeks.

While assembling the parts of our skateboard the installation of the bearings comes last after you mount the wheels on the board. To ensure you get the best out of your bearings, follow the steps outlined below while setting them up.

How To Put Bearings In Skateboard Wheels

How To Put Bearings In Skateboard Wheels

Placing the first bearing

Lay the board by its side. You bearing set should have a set of spacers  & washers which help hold the bearings to place once fixed.

So you put in the axle a bearing and use the hanger to press the wheel.

Place a wheel over the bearing being exactly over the bearing then press the bearing with the palm of your hand.

Spacing the first bearing from the second

After you get the first bearing pressed into the wheel you then remove it from the axle and place a spacer on it. It is quite unfortunate that you’ll find some people failing to use the spacer considering that the spacer helps keep the bearing in line as they would easily break under the lateral force exacted on them when the wheels are rolling. 

 It also allows you to tighten your axle nut and hence securing the inner race in place. This, however, makes rolling a little slow when new but this fades away once the bearing is broken in – something that happens as you start rolling.

See also: What Size Skateboard Wheels Do You Need

Fitting the washer

Ensure that the wheel can freely spin between your fingers then get two washers; place one against the hanger on the axle and the other against the wheel. This will keep the shields from rubbing against the hanger and the axle nut while rolling – something that would adversely affect the speed of rolling.

Tightening the nut

If by any chance you opt to use a spacer in the place of a washer, then you will have to watch your force when tightening the nut to ensure you maintain a steady spin of the wheel when rolling. After you are done you then test whether your wheel can spin steadily and freely by spinning it by hand.

If it stops suddenly, loosen the nut a bit and try again. Do this until the spinning becomes smooth and steady with a gradual stop rather than a sudden stop. The wheel should, however, be firmly held in place and not shaky. When you have your wheels well set then you will be good to go


When you read this, you may have partially answered the question “How To Put Bearings In Skateboard Wheels

In conclusion, it is important to keep in mind that

Bearings are accurate – design equipment – engineered equipment and will only work best when used together with the spacers and the washers. The speed of your skateboard would be slow at the beginning but will increase with usage when the bearings get broken in. 

 when doing a purchase of your bearings it is important to first check the size of your skateboard wheels so that you chose the ones that suit them. Always keep a close watch on your bearings and ensure they are clean and lubricated to always enjoy the full benefits of your bearings.

It is my hope that you enjoyed the read and found it helpful. Please feel free to refer a friend as you enjoy your ride!!!

In addition to bearings, you can see more: best beginner skateboard

Related posts:

How To Stop A Skateboard

How To Hang A Skateboard On The Wall

Click Here to Leave a Comment Below 0 comments

Leave a Reply:

Scroll Up